Tư vấn kỹ thuật |
||
Nhà sản xuất:Fluke
Mã sản phẩm:1587/ET-KIT
Xuất xứ:China
Bảo hành:12 tháng
Đồng hồ vạn năng Fluke 1587/ET-KIT
Hãng sản xuất : Fluke
Model: 1587/ET-KIT
Xuất xứ : China
Thông số kỹ thuật:
Voltage DC | |
Maximum Voltage | 1000 V |
Accuracy | ±(0.09%+2) |
Maximum Resolution | 0.001V |
Voltage AC | |
Maximum Voltage | 1000 V |
Accuracy | ±(2%+3) |
AC Bandwidth | 5kHz with low pass filter; 3db @ 800 Hz |
Maximum Resolution | 0.1 mV |
Current DC | |
Maximum Amps | 400mA |
Amps Accuracy | ±(0.2%+2) |
Maximum Resolution | 0.01 mA |
Current AC | |
Maximum Amps | 400mA |
Amps Accuracy | ±(1.5%+2) 1kHz bandwidth |
Maximum Resolution | 0.01 mA |
Resistance | |
Maximum Resistance | 50 MΩ |
Accuracy | ±(0.9%+2) |
Maximum Resolution | 0.1Ω |
Capacitance | |
Maximum Capacitance | 9,999 μF |
Accuracy | ±(1.2%+2) |
Maximum Resolution | 1 nF |
Frequency | |
Maximum Frequency | 100 kHz |
Accuracy | ±(0.1%+1) |
Maximum Resolution | 0.01 Hz |
Temperature Measurement | -40.0 °C to 537 °C -40.0 °F to 998 °F excluding probe |
Diode Test | |
Range | 6 V |
Resolution | 1 mV |
Accuracy | ±(2 % + 1) |
Insulation Test | |
Minimum Test Current @ 1kΩ/V | 1mA |
Test Voltages | 50, 100, 250, 500, 1000 V |
Maximum Resistance per Test Voltage | 100V: 2 GΩ |
Maximum Resolution per Test Voltage | 50V: 0.01 MΩ 100V: 0.01 MΩ 250V: 0.1 MΩ 500V: 0.1 MΩ 100V: 0.1 MΩ |
Accuracy per Test Voltage | 50V: ±(3 % + 5) 100V: ±(3 % + 5) 250V: ±(1.5 % + 5) 500V: ±(1.5 % + 5) 100V: ±(1.5 % + 5) to 600 MΩ, ±(10 % + 3) above 600 MΩ |
Environmental Specifications | |
Operating temperature | ?20 °C to +55 °C |
Storage temperature | -40°C to +60°C |
Humidity (Without Condensation) | 0% - 95% (10 °C – 30 °C) 0% - 75% (30 °C – 40 °C) 0% - 40% (40 °C – 55 °C) |
Operating Altitude | 2000 m |
Safety Specifications | |
Overvoltage category | Complies with ANSI/ISA 82.02.01 (61010-1) 2004, CAN/CSA-C22.2 NO. 61010-1-04, and IEC/EN 61010-1 2nd Edition for measurement CAT III 1000 V and CAT IV 600 V |
Agency Approvals | 2000 m CAT III 1000 V, CAT IV 600 V; 3000 m CAT II 1000 V, CAT III 600 V |
Mechanical & General Specifications | |
Size | 203 x 100 x 50 mm (with holster) |
Weight | 624 g |
Warranty | 3 years |
Battery life Alkaline | Meter use 1000 hours |
Insulation test use | Meter can perform at least 1000 insulation tests with fresh alkaline batteries at room temperature. These are standard tests of 1000 V into 1 MΩ with a duty cycle of 5 seconds on and 25 seconds off. |
IP Rating | IP40 |
Fluke i400 | |
Nominal current range | 400A |
Continuous current range | 1 A - 400 A |
Maximum Non-Destructive Current | 1000 A |
Lowest measurable current | 1 A |
Basic accuracy | 2% + 0.06 A (45-400 Hz) (% reading + floorspec) |
Useable frequency | 5 Hz - 20 kHz |
Output level(s) | 1 mA/A |
Safety Specifications | |
Safety | CAT IV 600 V, CAT III, 1000 V |
Maximum voltage | 1000 V AC rms from earth to ground, in compliance with EN61010 |
Mechanical & General Specifications | |
Warranty | 1 year |
Maximum conductor diameter | 32 mm (1.25 inches) |
Maximum conductor size (busbar) | 750 MCM |
Output cable length | 1.5 m (59 inches) |
Shrouded banana plugs | Yes |
Fluke 62 | |
Backlit display for use in poorly lit areas | Yes |
Holds temperature readings | Yes |
Range | -30 to 500 °C (-20° to 932 °F) |
MIN/MAX/AVG | MAX |
Datalogging | N/A |
Distance to spot ratio | 10:1 at 80% energy |
Hi-Lo Alarm | N/A |
Optional RTD probe (contact temperature measurement) | N/A |
Emissivity | Fixed at 0.95 |
Measurement Accuracy | 10 °C to 30 °C (50 °F to 86 °F) : ± 1 °C (2 °F) Outside 10 °C to 30 °C (50 °F to 86 °F) : ± 1.5 °C (3 °F) or ± 1.5 % of reading, whichever is greater |
Includes
Fluke 1587 Insulation Multimeter
Fluke i400 AC Current Clamp
Fluke 62 Mini IR Thermometer
Rugged, utility hard case to carry everything
Thước đo cho mọi công trình Yamayo Nhật Bản - Thiết bị kỹ thuật - Thiết bị đo lường - Thiết bị ngành sơn DeFelsko - Thiết bị đo ẩm Vải Aqua Boy - Đối tác: Máy đo khí